PROMOSOLV COAT UT10-UV
High-Performance Carrier Solvent for Ultra-Thin Coatings
- Ultra-thin hydrophobic & oleophobic coating with UV tracer
- Dipping & spray process
- Easy & fast process
PROMOSOLV COAT UT10-UV
A transparent hydrophobic and oleophobic ultra-thin coating to protect electronics and other surfaces against moisture, corrosion and other environmental conditions that could jeopardize the reliability of the device or surface. Adheres well to a wide variety of material substrates as plastic, glass, metal and ceramic. This product is formulated with a UV tracer for easy detection under UV light in order to support quality control.
PCBA Without coating
PCBA With coating
| SOLID CONTENT (WEIGHT %) | FILM THICKNESS |
|---|---|
| 2% | Dipping: 0,1–0,2 microns / Spray: not applicable |
| 8% | Dipping: 0,8–1 microns / Spray: not applicable |
| CHARACTERISTICS | VALUES |
|---|---|
| Chemical nature | Fluoropolymer |
| Appearance | Clear to slightly cloudy |
| Density (g/cm³) at 20°C | 1,4 |
| Solvent type | Hydrofluoroether |
| Solvent product name | DILUENT 10D |
| Solvent boiling point | 61°C / 142°F |
| Flash point | None |
| Viscosity (cSt) | ~1 |
| Surface tension (mN/m or dynes/cm) | 13,6 |
| CHARACTERISTICS | VALUES |
|---|---|
| Appearance | Clear, colourless |
| Surface energy (dynes/cm) | 5–10 |
| Contact angle (ASTM D7334-08) | 120° water – 80° oil |
| Heat stability | 150°C continuous / 250°C one hour |
| Solder-through repairability | Yes |
| Solvent and chemical resistance | Excellent |
| Refractive index | ~1,35 |
| Tg (glass transition temperature) | 75°C |
| Dielectric strength | 2500 V/mil (2500 V/25μm) |
| Dielectric constant | 2,25 @100 KHz |
| Dissipation factor | 0,016 @100 KHz |
| Volume resistivity | 4,5×10¹⁵ Ω·cm |
| Non flammability certificates | UL94 V-0 / NF EN 60695-11-10 |
| UL file | E547067 |
PROMOSOLV COAT UT10-UV is currently available at 2% and 4% solid content. A higher solid content will increase the coating thickness.
PROMOSOLV COAT UT10-UV can be considered as a replacement for 3M Novec 2704, which is scheduled to be phased out voluntarily by end 2025. More info on the announcement of 3M on the phase out of Novec products, click this link.
Show links
Hide linksPERFORMANCE
- Provides exceptional repellence of all kinds of liquids.
- Fast drying at room temperature ( <1 min)
- UV tracer with wide detection spectrum for easy quality control
COST
- Substantial cost reduction due to small amount of product needed and simplicity of process.
- PCB masking is not required, saving on preparation time.
HSE
- No CMR substances
- Low environmental impact & very low VOC
- Non flammable
PROCESS EXAMPLES
Dip coating
- Dipping process recommended / spray application possible (especially for selective deposition)
- Typical coating thickness is about 0.2 microns
- Recommended to apply on cleaned and dried surfaces
- Touch dry within less than a minute / No thermal or UV cure required
Related products & services
PROMOSOLV COAT UT10
